At^stpb Transmit Parity Bit (For 7E1 And 7O1 Only) - Siemens TC35i User Manual

TC35i AT Command Set
4.12 AT^STPB
4.12

AT^STPB Transmit Parity Bit (for 7E1 and 7O1 only)

This command is intended only for use with 7E1 and 7O1. In addition to the 7E1 or 7O1 settings made with
the command
AT+ICF AT^STPB
Syntax
Test Command
AT^STPB=?
Response(s)
^STPB: (list of supported
OK
Read Command
AT^STPB?
Response(s)
^STPB: <n>
OK
Write Command
AT^STPB=<n>
Response(s)
OK
ERROR
+CME ERROR: unknown
PIN ASC0 MUX1
! % %
Reference(s)
SIEMENS
Command Description
The test command returns the supported values of the parameter
The read command returns the current value of the parameter
The write command can be used to control the handling of the parity bit. If command fails, "+CME ERROR:
unknown" will be returned.
TC35i_ATC_V02.07
Confidential / Released
specifies whether or not to transmit the parity bit over the air.
s)
<n>
MUX2 MUX3
! !
Page 107 of 439
s
.
<n>
.
<n>
m
obile
1/30/04