Siemens TC35i User Manual page 56

TC35i AT Command Set
2.14 AT^SCFG
<AutoExecType>
value
0
1
Value will be saved while switching off the TC35i via AT commands (e.g.
on next power up.
(str)(+CSCS)
<AutoExecPeriod>
AutoExec AT Command Period
Parameter specifies the period after which
characters indicate hours and minutes. This parameter applies for
Due to the internal activity and network signalling an execution delay of several seconds may occur for the over-
all procedure.
Value will be saved while switching off the TC35i via AT commands (e.g.
on next power up.
000:00:05...240:00:00
Notes
• Automatic dialing on DTR line activation can also be enabled via
=0 shall not be used at the same time. If both kinds of DTR triggered autoexecution are enabled only
Type>
related action will be performed.
AT%D
• Please keep in mind, that each time the ME is restarted the timers of all autoexec actions configured with
=1 and
<AutoExecType>
action configured at a time later then a scheduled automatic restart would never be executed.
• Please be careful using
since only little time remains to change these settings again after TC35i restart.
• If uses AT commands containing secret data, this information may be retrieved with
<AutoExecATC>
?. For instance, this applies if using
AT^SCFG
TC35i_ATC_V02.07
Confidential / Released
<AutoExecType>
event
ASC0 DTR line activation
<AutoExecPeriod>
<AutoExecATC>
<AutoExecPeriod>
=1 with small period values and shutdown or reset AT commands,
<AutoExecType>
AT+CPIN
Page 56 of 439
Valid Indicies
0
expiration 0-2
AT+CFUN
will be executed. Format is "hhh:mm:ss", where
<AutoExecPeriod>
AT+CFUN
. However,
AT%D
will be reinitialized and restarted. As a result, an autoexec
.
s
m
obile
or ) and restored
AT^SMSO
=1 only.
or ) and restored
AT^SMSO
and
AT%D <AutoExec-
1/30/04