TC35i AT Command Set
11.11 AT+CNMI
2
3
(num)(&W)(&V)
<mt>
Rules for storing received SMS depend on the relevant data coding method (refer to GSM 03.38), preferred
memory storage (
AT+CPMS
Note: If AT command interface is acting as the only display device, the ME must support storage of class 0 mes-
sages and messages in the message waiting indication group (discard message)
(&F)
[0]
1
2
3
(num)(&W)(&V)
<bm>
Rules for storing received CBMs depend on the relevant data coding method (refer to GSM 03.38), the setting
of Select CBM Types (
AT+CSCB
(&F)
[0]
2
3
(num)(&W)(&V)
<ds>
(&F)
[0]
1
2
(num)(&W)(&V)
<bfr>
(&F)
[1]
(num)
<index>
Integer type; value in the range of location numbers supported by the associated memory
Notes
•
Each time an SMS or Cell Broadcast Message is received, the Ring Line goes Logic "1" for one second.
TC35i_ATC_V02.07
Confidential / Released
Buffer unsolicited result codes in the TA when TA-TE link is reserved (e.g. in
on-line data mode) and flush them to the TE after reservation. Otherwise for-
ward them directly to the TE.
Forward unsolicited result codes directly to the TE. TA-TE link specific inband
technique used to embed result codes and data when TA is in on-line data
mode.
) setting and this value.
No SMS-DELIVER indications are routed to the TE.
If SMS-DELIVER is stored in ME/TA, indication of the memory location is
routed to the TE using unsolicited result code.
SMS-DELIVERs, except class 2 messages and messages in the message
waiting indication group (store message) are routed directly to the TE using
unsolicited result code.
Class 3 SMS-DELIVERs are routed directly to the TE using unsolicited result
codes defined in
<mt>
indication as defined in
) and this value:
No CBM indications are routed to the TE.
New CBMs are routed directly to the TE using unsolicited result code.
Class 3 CBMs are routed directly to TE using unsolicited result codes defined
in
=2.
<bm>
No SMS-STATUS-REPORTs are routed to the TE.
SMS-STATUS-REPORTs are routed to the TE using unsolicited result code.
If SMS-STATUS-REPORT is routed into ME/TA, indication of the memory
location is routed to the TE using unsolicited result code.
TA buffer of unsolicited result codes defined within this command is cleared
when
1...3 is entered.
<mode>
Page 295 of 439
=2. Messages of other data coding schemes result in
=1.
<mt>
s
m
obile
1/30/04