At&V Display Current Configuration; At&V Responses - Siemens TC35i User Manual

TC35i AT Command Set
2.2 AT&V
2.2 AT&V Display current configuration
Syntax
Exec Command
AT&V [ ]
<value>
Response(s)
ACTIVE PROFILE:
... (see section 2.2.1)
OK
PIN ASC0 MUX1
! % %
Reference(s)
V.25ter
Command Description
TA returns the current parameter setting. The configuration varies depending on whether or not PIN authentica-
tion has been done and whether or not Multiplex mode is enabled (see
Parameter Description
(num)
<value>
[0]
Notes
• The value of \Q (flow control) is also determined by the
cannot be represented by a \Q equivalent, \Q255 will be displayed.
• The parameters of
AT^SMGO
fully for the first time. Reading starts after successful SIM authentication has been performed, and may take
up to 30 seconds depending on the SIM used. While the read process is in progress, an attempt to read the
parameter will result in empty values.
• The parameter of
AT+CSDH
2.2.1 AT&V responses
The following tables show four different kinds of responses depending on whether or not the PIN is entered and
whether or not the Multiplex mode is enabled (see
TC35i_ATC_V02.07
Confidential / Released
MUX2 MUX3
§ §
Profile number
can only be displayed after the SMS data from the SIM have been read success-
will only be displayed in SMS text mode, see
AT+CMUX
Page 29 of 439
).
AT+CMUX
command. In case the value set by
AT+IFC
AT+CMGF
).
s
m
obile
AT+IFC
1/30/04