At^ssync Configure Sync Pin - Siemens TC35i User Manual

TC35i AT Command Set
16.6 AT^SSYNC
16.6

AT^SSYNC Configure SYNC Pin

The command serves to configure the SYNC pin of the application interface. The applicability of the
AT^SSYNC
different types of
<mode>
• If you have a TC35i module you may select either mode, depending on whether your application is designed
to use the SYNC mode (indicates the current consumption in a transmit burst) or the LED mode (drives a
status LED connected to the pin). See
• In the case of the TC35i Terminal the
on the front panel. Therefore, the SYNC mode (
be found in [6].
Syntax
Test Command
AT^SSYNC=?
Response(s)
^SSYNC: list of supported
OK
Read Command
AT^SSYNC?
Response(s)
^SSYNC:<mode>
OK
Write Command
AT^SSYNC=<mode>
Response(s)
OK
PIN ASC0 MUX1
! % %
Reference(s)
SIEMENS
TC35i_ATC_V02.07
Confidential / Released
is product dependent:
[2] for further details on both modes.
AT^SSYNC
s
<mode>
MUX2 MUX3
% %
Page 407 of 439
command is intended only to control the status LED placed
=0) is not applicable. Further details on the LED can
<mode>
s
m
obile
1/30/04