Atz Set All Current Parameters To User Defined Profile - Siemens TC35i User Manual

TC35i AT Command Set
2.8 ATZ
2.8

ATZ Set all current parameters to user defined profile

Syntax
Exec Command
ATZ [ ]
<value>
Response(s)
OK
PIN ASC0 MUX1
! % %
Reference(s)
V.25ter
Command Description
TA sets all current parameters to the user profile stored with
nated.
The user defined profile is stored to the non-volatile memory.
Parameter Description
(num)
<value>
[0]
Notes
• First the profilewill be set to factory default (see
profile will be loaded afterwards.
• Any additional commands on the same command line may be ignored. A delay of 300 ms is required before
next command is sent, otherwise "OK" response may be corrupted.
TC35i_ATC_V02.07
Confidential / Released
MUX2 MUX3
% %
Reset to user profile
AT&F
Page 38 of 439
. If a connection is in progress, it will be termi-
AT&W
). If there is a valid user profile (stored with
s
m
obile
), this
AT&W
1/30/04