Table of Contents
Advertisement
TC35i AT Command Set
8.7 AT^MONI
NCC and BCC. Until the information is received from the new base station, the default values will be shown
instead: cell="0000", NCC="-", BCC="-".
•
If the BS supports frequency hopping during a connection, the dedicated channel (parameter chann) is not
stable. This mode is indicated by chann = 'h'.
•
To some extent, the cell monitoring command
for example, can be queried with both commands. Yet the resulting values may be slightly different, even
though obtained over a time period of a few seconds. This is quite normal and nothing to worry about, as the
cell information is permanently updated.
•
for compatibility with earlier products and to support legacy applications, any input character may be used to
stop the output in certain cases (depending on the settings of
103).
TC35i_ATC_V02.07
Confidential / Released
covers the same parameters. The receiving level,
AT^SMONC
Chapter 4.10, page 100
Page 202 of 439
s
m
obile
and
Chapter 4.11, page
1/30/04
- Quick Links:
- Quick Reference Table
- At Command Syntax
Hide quick links:
Advertisement
Table of Contents
