Siemens TC35i User Manual page 285

TC35i AT Command Set
11.6 AT+CMGR
PIN ASC0 MUX1
% % %
Reference(s)
GSM 07.05
Command Description
The write command returns SMS message with location value
TE. If status of the message is 'received unread', status in the storage changes to 'received read'.
Notes
• Response if
AT+CMGR
• Response if
AT+CMGR
• The parameters
<ra>
set to 1.
• Filler "FF" will not be displayed in PDU status reports if parameter
to 1.
• This command can be used only after the SMS data from the SIM have been read successfully for the first
time. Reading starts after successful SIM authentication has been performed, and may take up to 30 seconds
depending on the SIM used. While the read process is in progress, an attempt to use any of the SMS read
commands will result in ''+CME Error: 14'' (SIM busy)
• We recommend to take advantage of the "^SSIM READY" URC. If enabled with
edges to the user that SIM data is accessible after SIM PIN authentication. It will be delivered once the ME
has completed reading data from the SIM card.
TC35i_ATC_V02.07
Confidential / Released
MUX2 MUX3
% %
is used to read an empty record index: +CMGR: 0,,0
is used to read a non-existent record index: +CMS ERROR: invalid memory index
and will only be displayed if parameter
<tora>
Page 285 of 439
s
from message storage
<index>
of the
<ra> AT^SSCONF
of the
<ff> AT^SSCONF
AT^SSET
m
obile
to the
<mem1>
command is
command is set
, this URC acknowl-
1/30/04