Promega GloMax Operating Manual page 66

2. Manually open the plate door, and using the Phillips-Head Screwdriver, loosen the two screws at the bottom
sides of the door (Figure 65).
3. Next, pull the front access door toward you to remove the door (Figure 65).
4. Remove the filter paddle by gently pushing it in and then up. The slide should pop up so that you can
remove it.
5. Tap Next to continue.
Figure 65. Filter Configuration procedure.
6. Several Filter Configuration options exist, depending upon whether you are configuring fluorescence or
luminescence (Figures 66–69).
a. Fluorescence or Custom Fluorescence
b. BRET/Filtered Luminescence or Custom Luminescence
7. Add the appropriate Filter Paddle of interest by inserting it using the reverse process that you used to
remove it.
Tap Next to complete the reconfiguration.
8.
Figure 66. Filter configuration procedure (part 1).
Promega Corporation · 2800 Woods Hollow Road · Madison, WI 53711-5399 USA · Toll Free in USA 800-356-9526 · 608-274-4330 · Fax 608-277-2516
www.promega.com
65
TM397 · Revised 8/18