Automation Direct DL405 User Manual page 264

The following table provides the specifications for the F4–04DA–2 Analog Output
Module. Review these specifications to ensure the module meets your application
requirements.
Output
Number of Channels
Specifications
Output Ranges
Resolution
Load Impedance
Load Capacitance
Voltage Output Current
Short-circuit Current
Linearity Error (end to end)
and Relative Accuracy
Offset Calibration Error
Full Scale Calibration Error
Maximum Inaccuracy
Conversion Time
General
Digital Output Points Required
Module
Specifications
Power Budget Requirement
External Power Supply
Accuracy vs. Temperature
Operating Temperature
Storage Temperature
Relative Humidity
Environmental air
Vibration
Shock
Noise Immunity
F4–04DA–2 Analog Voltage Output
4, single ended (one common)
0–5, 0–10, $5 , $10 VDC
12 bit (1 in 4095)
2KW minimum
0.01 uF maximum
5.0 mA sink or source
15 mA typical
$1 count ($0.025%) maximum
$3 counts maximum, unipolar
$4 counts maximum, bipolar
$8 counts maximum, (offset error included)
$0.2% @ 25_C (77°F)
$0.4% @ 0 to 60_ C (32 to140°F)
5 ms maximum, settling time
2.0 ms maximum, digital out to analog out
16 point (Y) outputs,
12 bits binary data, 4 active channel bits or 2
active channel bits and 1 sign bit for bipolar
90 mA @ 5 VDC (from base)
21.6–26.4 VDC, 90 mA, class 2
(outputs fully loaded)
$57 ppm / _C full scale calibration change
(including maximum offset change, 2 counts)
0 to 60_C (32 to 140°F)
–20 to 70_C (–4 to 158°F)
5 to 95% (non-condensing)
No corrosive gases permitted
MIL STD 810C 514.2
MIL STD 810C 516.2
NEMA ICS3-304
14–3