Set Ip Addresses - Siemens CP-8000 User Manual

Engineering via SICAM WEB
9.1.2.4

Set IP Addresses

The settings of the IP addresses reside in the directory tree under
SICAM A8000 CP-80xx | Master module | Network settings | IP
With engineering in a network (company intranet, networked plant), conformable IP addresses
must be assigned. The IP address for the web server of your target devices can be changed
with the parameter
Note
The IP settings depend on the configuration and the used transmission media of your network. For the
setting of these parameters please contact your network administrator.
The details for the setting of the advanced parameters for secure network configurations can be found in
the SICAM RTUs • SICAM TOOLBOX II Administrator Security Manual.
With the parameter
X4 are operated via the same or via 2 separate IP addresses. The presetting is
(connected ports in switch
Note
The IP address set via SICAM WEB is only relevant without use of a DHCP server (parameter
Autoconfiguration
With use of a DHCP server the target device receives the the IP address automatically. Further details see
9.1.2.7, Autoconfiguration
With the selection
X4. Thereby the target device can be accessed also via X4 independently of the network set-
tings on X1, for instance
·
X1: process LAN
·
X2: office LAN
The server services of CP-8000/CP-802x are accessible on both interfaces.
The further possibilities resulting thereout are described in Appendix E,
320
Unrestricted
Own IP address.
Mode of ethernet ports
mode).
= NO).
(restricted operation mode).
2 IP addresses (independent ports)
address.
you can define whether the interfaces X1 and
you can define a 2
SICAM A8000 / CP-8000 • CP-8021 • CP-8022 Manual
DC8-037-2.02, Edition 10.2017
1 IP address
nd
IP address for
Use Cases.