Settings Of The Messages - Siemens CP-8000 User Manual

9.1.7.4

Settings of the Messages

The settings of the messages reside in the directory tree under
SICAM A8000 CP-80xx | Master module | Communication |
101/104
(the checkbox S
These settings are independent on the communication type and exist on the Master Module
individually for each protocol element:
·
Transmission with/without time tag
·
Variable elements of the message
·
Command time monitoring
·
Monitoring ACTCON
Transmission with/without time tag
The information objects supported by CP-8000/CP-802x can be transmitted to the control cen-
ter either with time tag or without time tag. The definition happens selectively for each type
identification.
You find the parameters thereto in the subdirectory
Variable elements of the message
For the communication with different systems the byte numbers of the identifiers in the mes-
sage header can be parameterized.
The settings on the Master Module reside in the subdirectory under
ble elements of the
You find the information thereto in the manual SICAM RTUs Common Functions System and
Basic System Elements, Appendix "Message Formats".
The settings on the protocol element reside in the directory tree under
SICAM A8000 CP-80xx | Master module | PRE <0...3>:
IEC 60870-5-101
You find the information thereto in the manual SICAM RTUs Common Functions Protocol El-
ements, chapter "Multi-Point Traffic (UMP)", section "Communication according to
IEC 60870-5-101", "Data Acquisition by Polling (Station Interrogation)".
SICAM A8000 / CP-8000 • CP-8021 • CP-8022 Manual
DC8-037-2.02, Edition 10.2017
must be activated).
HOW ALL PARAMETERS
message.
(applies only for point-to-point traffic and multi-point traffic).
Engineering via SICAM WEB
PRE<0...3> | IEC60870-5-
Transmission with/without time
Varia-
| Advanced settings |
<protocol >
Unrestricted
tag.
343