Mounting Of The Bus Connector For Sicam I/O Modules - Siemens CP-8000 User Manual

6.4.4.2

Mounting of the Bus Connector for SICAM I/O Modules

Each SICAM I/O Module is equipped with a bus connector (CM-8812). This must be equipped
separately from the I/O Module. You must disconnect the bus connector before mounting.
Click the first bus connector right beside the coupling module on the DIN rail
to the bus plug of the coupling module
F1 F2
Afterwards you can attach the bus connectors of further SICAM I/O Modules in the same way.
6.4.4.3 Mounting of the SICAM I/O Modules
The SICAM I/O Modules can be mounted as shown in following picture.
SICAM A8000
F 1 F2 F3
Note
The tongue and groove system integrated in the modules facilitates the correct combination. The module
is only connected correctly when the locking hook is snapped onto the DIN rail.
SICAM A8000 / CP-8000 • CP-8021 • CP-8022 Manual
DC8-037-2.02, Edition 10.2017
k
SICAM CMIC
SICAM A8000
CP -8000
P OK
R Y
E R
E TH
LK1
P K1
R S -2 32
OH2
R TX 2
R S -4 85
OH3
R TX 3
E TH
LK4
P K4
S D
X4
F 3 F 4
SIC AM C MIC
CP -8000
P OK
R Y
E R
E T H
LK 1
P K 1
R S-232
OH 2
R TX2
R S-485
OH 3
R TX3
E T H
LK 4
P K 4
S D
X 4
F 4
RY
. Both elements must be aligned seamlessly.
k
j
Unrestricted
Installation and Circuitry
j
and push it in-
181