Switching The Device On And Off - Siemens CP-8000 User Manual

Installation and Circuitry
6.8

Switching the Device On and Off

Before switching the device on it must be connected to the designated power supply.
Switching on takes place by connecting the voltage at the corresponding connector
(X12/CP-8000, X1/PS-862x, X1/PS-864x), commonly by switching on a miniature circuit
breaker (Details see 6.7.1,
The circuit breaker must be arranged at a suitable location, simply accessible to the user,
close to the device, and be marked as disconnector for the device.
The device starts up automatically. It is operational (without error display), as soon as all con-
nected modules have concluded the startup. The startup time is dependent on the loaded data
on the SD card and may last up to 15 minutes.
Pay attention to the status display during and after startup. You will find the details therreto in
section 11.2,
The switching off of the device takes place by disconnecting the power supply.
Caution
Switching off during writing operations to the SD card (load firmware, load parameters) is to be avoided
without fail, since the data on the SD card could be destroyed as a result.
198
Unrestricted
Power Supply).
Checks and System Display.
SICAM A8000 / CP-8000 • CP-8021 • CP-8022 Manual
DC8-037-2.02, Edition 10.2017