Change Web Server Password - Siemens CP-8000 User Manual

Engineering via SICAM WEB
Schematic Procedure of the Authentication
SICAM WEB
9.1.2.2

Change Web Server Password

The change of the password for the web server takes place in the directory tree under
SICAM A8000 CP-80xx | Master module | Network settings | IP address |
HTTP web server.
After the initial logon, an indication appears that a password must be defined. The password is
required in order to protect the respective target device against unauthorized access.
To change the settings, the parameter
Note
With engineering via SICAM WEB, the HTTP web server is system-internally fixed enabled.
After transfer of the entered values, a new logon is only possible with the current password.
Password Assignment Rules
The following entries are allowed:
·
Empty password possible (only with non-secure password)
·
Maximum 8 characters
·
Digits 0...9
·
Letters A...Z and a...z (no umlauts)
·
Special characters !?§$%&/\(){}[]=^°´`'@*#|+-,.;:_
·
A secure password must contain at least one digit, one uppercase letter, one lowercase
letter and one special character
Note
In case of problems with passwords please contact the Siemens Support Center.
316
Unrestricted
SICAM CP-8000
a
Protocol: HTTPS
HTTP web server
SICAM A8000 / CP-8000 • CP-8021 • CP-8022 Manual
RADIUS Server
ti
Pa
Protocol: RADIUS
must be set to enabled.
DC8-037-2.02, Edition 10.2017