6.5.3.1
Mounting of the Power Supply Module
The Power Supply Module is equipped with a bus connector (CM-8812). This must be
equipped separately from the module. You must disconnect the bus connector before mount-
ing.
Click the bus connector right beside the Master Module on the DIN rail
bus plug of the Master Module
The Power Supply Module can be mounted as shown in the following picture.
Note
The tongue and groove system integrated in the modules facilitates the correct combination. The module
is only connected correctly when the locking hook is snapped onto the DIN rail.
SICAM A8000 / CP-8000 • CP-8021 • CP-8022 Manual
DC8-037-2.02, Edition 10.2017
k
. Both elements must be aligned seamlessly.
k
j
Unrestricted
Installation and Circuitry
j
and push it into the
191