Installation And Commissioning; Installing The Hardware; Logo! 8 And Logo! Tde; Logo! Cmr - Siemens LOGO! 8 Manual

5 Installation and Commissioning

5.1 Installing the hardware

5 Installation and Commissioning
This chapter describes the steps necessary to start up the example with the code
from the download and the hardware list.
5.1 Installing the hardware
5.1.1

LOGO! 8 and LOGO! TDE

Please note the respective setup guidelines for LOGO! 8 and LOGO! TDE. Further
information is available in the LOGO! manual in Chapter
wiring".
5.1.2

LOGO! CMR

Please note the respective setup guidelines for LOGO! CMR2020 or LOGO!
CMR2040, as well as for the used mobile telecommunications antenna. Further
information is available in the LOGO! CMR manual in Chapter
connecting up, commissioning".
For the LOGO! CMR, IP address 192.168.0.3 is used here (already default in
LOGO! CMR).
Note
When using LOGO! CMR, please note the country approvals for mobile network
based products. Further information is available under the following link:
www.siemens.com/mobilenetwork-approvals.
5.1.3

Contactor with auxiliary motor

For this application, it is recommended not to control the street lights directly via
the LOGO! outputs but by using a contactor with auxiliary contact. The contactor is
controlled by means of a LOGO! output. In this application example, LOGO! output
Q1 was used.
Further information on how the contactor must be wired and which setup guidelines
must be observed are available in the
5.2

Installing the software

Note It is assumed that the necessary LOGO!Soft Comfort V8 software has been
installed on your PC and that you are familiar with the basic handling of this
software.
5.3

Commissioning

5.3.1

Assigning IP addresses and subnet masks to devices

For LOGO! 8 and LOGO! TDE, one IP address and one subnet mask each must be
assigned so they are located in the same subnet.
LOGO! Set 1
Entry ID: 109063024, V1.0, 07/2015
"LOGO! installation and
Device manual for SIRIUS contactors
"Installation,
18