Command Execution Key: Illuminating Condition; Blinking At Command Execution Key - IDK MSD-6203 User Manual

9.14.7 Command execution key: Illuminating condition

Menu Top→PRESET COMMAND→COMMAND TALLY
Setting for Each control command execution key
Setting value REGISTERED : Illuminates if a control command is registered
EXECUTION : Illuminates while a control command is executed
If you set "LINK" to "ON", you can change all lighting conditions at once.
*1
There are two planes (PLANE A and B) for each execution condition of COMMANDs A to I. If you register
control commands for both planes, the control commands are executed alternatively every time you press
the command key as follows.
*2
If execution duration is 500 ms or shorter, the key illuminates for 500 ms. It also blinks by changing the
setting of "9.14.8 Blinking at command execution key".
Illuminating If you register a command only for one
condition
REGISTERED Illuminates if a control command is
registered
EXECUTION Illuminates while a control command is
being executed

9.14.8 Blinking at command execution key

Menu Top→PRESET COMMAND→FLASH TIME
Setting for Each control command execution key, each display power key
Setting value
EXECUTION
OFF
1sec. to 1000sec. : Blinks for the specified time (1 to 1000 sec.)
You can set the blinking duration of command execution keys and power switch of sink devices during
command execution.
While control commands are being executed, these keys blink regardless of this menu's setting.
[Table 9.31] Illuminating condition
plane
: Blinks while a control command is being executed
[Default] (DISPLAY POWER key)
: Not blink [Default] (Control command key)
MSD-62 Series User's Guide
*1
[Default]
*1 *2
If you register commands for both two
planes
Illuminates if PLANE A will be executed at
the next press; blinks if PLANE B will be
executed at the next press.
Illuminates if PLANE A will be executed at
the next press; turned off if PLANE B will be
executed at the next press.
129