Table of Contents
Advertisement
Setting item
COM
RECV
yes
DISPLAY
*1
DELIMITER
yes
*2
RCV CHECK
yes
*3 *4
TIME OUT
yes
*3 *4
RETRY
yes
*3 *4
INTERVAL
yes
*3 *4
ERROR
yes
Contact
no
closure control
Pulse width
no
HDMI CEC
no
*7
control
Process for
no
CEC error
MEMO
yes
[Table 9.24] Setting control command (Cont'd)
CC
CEC
no
no
Set whether received data is displayed or
not.
no
no
Set the delimiter to be sent at the end of
the received data.
"NONE": delimiter is not checked and all
received data within the set timeout will be
valid.
Value other than "NONE": delimiter is
checked and data received before
delimiter will be valid.
no
no
Set whether reply command that may be
returned is checked or not.
no
no
Set the timeout time for reply command to
a sent command.
no
no
Set the number of retries to resend the
same command again if no valid
response is replied.
no
no
Set the retry interval to resend the
command.
no
no
Set whether the next command is to be
executed or not if no valid response is
replied, even after completing retry for the
set number of retries.
yes
no
Set the contact closure control.
If you select "toggle operation", it can
invert the condition of contact
(open/close).
yes
no
Set the time of returning its original
condition when you control the contact
closure.
no
yes
Set the CEC control for the sink devices
connected to OUT1 to OUT8.
Set whether the next command is
no
yes
executed or not if no response is replied
from the sink device that is controlled with
CEC.
Register a note up to 14 characters.
yes
yes
The registered note is displayed when the
control command is executed.
Description
MSD-62 Series User's Guide
Range
OFF [Default]
ASCII
HEX
NONE: Not checking delimiter
[Default]
00 to FF (Hex)
CHECK
NOT CHECK [Default]
0ms to 99s999ms
[Default] 0ms
0 to 99 (times)
[Default] 0
0ms to 99s999ms
[Default] 0ms
STOP [Default]
EXEC: Continue
-: Not controlling contact
closure [Default]
OFF: Opening contact
ON: Closing contact
TGL: Toggle
NONE: Eternity [Default]
100ms to 9990ms (by 10ms)
-: Not controlling CEC
[Default]
POWER OFF
POWER ON
STOP [Default]
EXEC: Continue
20 to 7D in ASCII codes
except for 2C (,)
[Default] 20 (space)
119
Advertisement
Table of Contents
