IDK MSD-6203 User Manual page 124

MSD-62 Series User's Guide
■ Setting loop back function
If the MSD sends a communication command back to the MSD itself using the loop back function, the MSD
replies "OK" if processed normally while it replies "NG" if parameter or command is incorrect. (This differs
from reply commands to communication commands received externally; not loop back.) Since "OK" and "NG"
are registered to reply commands 31 and 32 by factory default, respectively, do not edit or delete those
commands if you use the loop back function and check reply commands.
SIZE
Number
1 0 byte
2 0 byte
: :
30 0 byte
31 2 bytes
32 2 bytes
■ Setting PJLink
For setting PJLink, see "Setting PJLink".
124
[Table 9.29] Default value of reply command
PROCESS DATA
EXEC All: 00
EXEC All: 00
: :
EXEC All: 00
EXEC OK
STOP NG
MASK
All: FF All: 20 (space)
All: FF All: 20 (space)
: :
All: FF All: 20 (space)
All: FF OK
All: FF NG
MEMO