Lip Sync; Sampling Frequency - IDK MSD-6203 User Manual

9.10.5 Lip sync

Menu Top→AUDIO→OUTPUT LIP SYNC (Output side) / INPUT LIP SYNC (Input side)
Setting for Output side: Each output channel
Input side: Each input channel, each input signal
Setting value 0FRAME to 8FRAME [Default]0FRAME
You can adjust the gap between video (motion) and audio (sound).
Up to eight frames (up to 16 frames in total) can be set for each input/output channel.
If sampling frequency is 192 kHz and vertical synchronous frequency is 24 Hz / 25 Hz / 30 Hz, the total
maximum values of lip sync input / output channel are as follows:

Sampling frequency

192 kHz
Other conditions
*
Up to 8 frames can be set for each input / output channel lip sync, but lip
sync is limited to the maximum value.
9.10.6 Sampling frequency
Menu Top→AUDIO→SAMPLING FREQUENCY
Setting for Each output channel
Setting value
・AUTO [Default]
・192kHz
You can set the sampling frequency of digital audio output.
■ "AUTO"
Outputting digital audio at the maximum sampling frequency supported by the sink device that is connected to
the HDMI output connector. At this time, the sampling frequency that is actually output is displayed in
parentheses. In case EDID cannot be read from the sink device, the sampling frequency that was used the
last time is selected with "*" on its right side.
Maximum sampling frequency
[Table 9.15] Maximum lip sync value
Vertical synchronous
24 Hz
25 Hz
30 Hz
・96kHz
・88.2kHz
[OUT1 FREQUENCY]
AUTO(48kHz)
Lip sync maximum
frequency
Up to 8 frames
Up to 8 frames
Up to 10 frames
Up to 16 frames
・48kHz
・44.1kHz
[OUT1 FREQUENCY]
AUTO(48kHz)*
Sampling frequency used last time
MSD-62 Series User's Guide
value
*
*
*
・32kHz
101