Log Of The Settings For The Basic Functions, Firmware V4.4 - Siemens Sinamics G110M Original Instructions Manual

Machine manufacturer
This confirms that the settings recorded above are correct.
Date
... ...
A.7.3 Log of the settings for the basic functions, firmware V4.4 ... V4.7 SP2
Drive = <pDO-NAME_v>
Table A- 10 Firmware version
Name
Control Unit firmware version
SI version, safety functions integrated in the drive (processor 1)
Table A- 11 Monitoring cycle
Name
SI monitoring clock cycle (processor 1)
Table A- 12 Checksums
Name
SI module identifier, Control Unit
SI module identifier, Power Module
SI reference checksum SI parameters (processor 1)
SI reference checksum SI parameters (processor 2)
Table A- 13 Settings of the safety functions
Name
SI enable, functions integrated in the drive
Only for the CU250S-2
Control Unit
SI PROFIsafe address
F-DI switch over discrepancy time
SI STO debounce time
Only for the CU250S-2
Control Unit
SINAMICS G110M Operating Instructions
Operating Instructions, 04/2015, FW V4.7.3, A5E31298649B AD
Name
SI enable safe brake control
SI Safe Stop 1 delay time
A.7 Acceptance tests for the safety functions
Company/dept.
...
Number
r18
r9770
Number
r9780
Number
r9670
r9672
p9799
p9899
Number
p9601
p9602
p9610
p9650
p9651
p9652
Signature
...
Value
<r18_v>
<r9770_v>
Value
<r9780_v>
Value
<r9670_v>
<r9672_v>
<p9799_v>
<p9899_v>
Value
<p9601_v>
<p9602_v>
<p9610_v>
<p9650_v>
<p9651_v>
<p9652_v>
Appendix
329