Commissioning
5.2 Basic commissioning
5. Acknowledge this message, and set the "Access point" to "DEVICE (STARTER, Scout)"
and the "PG/PC interface" to "S7USB".
6. Then click on "Update". The connected converters are now displayed in "Accessible
nodes".
7. Close this screen form without selecting the converter(s) that has/have been found.
8. Create your STARTER project (Page 108).
You have set the USB interface.
5.2.7.2
Generating a STARTER project
Creating a STARTER project using project wizards
Procedure
To create a project with the STARTER project Wizards, proceed as follows:
1. Using "Project / New with
wizard" create a new project.
2. To start the wizard, click on
"Search online for drive
units ...".
3. Follow the instructions of the
Wizard, and set everything that
you require for your particular
project.
108
SINAMICS G110M Operating Instructions
Operating Instructions, 04/2015, FW V4.7.3, A5E31298649B AD