Terminal Assignment Dependent On Interface Configuration; Wiring Example For The Factory Settings - Siemens Sinamics G110M Original Instructions Manual

Cable screening
The screen of the PROFINET cable must be connected with the protective earth. The solid
copper core must not be scored when the insulation is removed from the core ends.
4.3.6

Terminal assignment dependent on interface configuration

The inputs and outputs of the frequency inverter and the fieldbus interface have specific
functions when set to the factory settings.
When you put the frequency inverter into operation, you can change the function of each of
its inputs and outputs and the setting of the fieldbus interface.
To make the setting process easier, the inverter has various predefined assignments
(macros).
Only the inputs and outputs whose functions change by selecting a specific assignment, are
shown on the following pages.
Procedure
To select one of the inverter's pre-assigned settings, proceed as follows:
1. Think about which of the input and output functions you are using in the application.
2. Find the I/O configuration (macro) that best suits your application.
3. Note the macro number of the corresponding default setting.
You must set this macro number when putting the frequency inverter into operation.
You have found the appropriate inverter pre-assignment.
4.3.7

Wiring example for the factory settings

To ensure that the factory setting can be used, you must wire your drive as shown in the
following examples.
Factory pre-assignment of the interfaces on the drive
For a complete technical specification of the individual connections, as shown in the
following diagram, please refer to following figures:
● Figure 4-11 SINAMICS G110M CU240M USS terminal diagram (Page 68)
● Figure 4-12 SINAMICS G110M CU240M PROFIBUS terminal diagram (Page 69)
● Figure 4-13 SINAMICS G110M CU240M PROFINET terminal diagram (Page 70)
● Figure 4-14 SINAMICS G110M CU240M ASi terminal diagram (Page 71).
SINAMICS G110M Operating Instructions
Operating Instructions, 04/2015, FW V4.7.3, A5E31298649B AD
Installation
4.3 Electrical Installation
75