Activating Diagnostics Via The Control; Communication Via Profibus; What Do You Need For Communication Via Profibus - Siemens Sinamics G110M Original Instructions Manual

7.2.5

Activating diagnostics via the control

The converter provides the functionality to transmit fault and alarm messages (diagnostic
messages) to the higher-level control according to the PROFIdrive error classes.
You must select the functionality in the higher-level control (see Manuals for your converter
(Page 334)) and activate it by booting up.
7.3

Communication via PROFIBUS

7.3.1

What do you need for communication via PROFIBUS?

Check the communication settings using the following table. If you answer "Yes" to the
questions, you have correctly set the communication settings and can control the converter
via the fieldbus.
Questions
Is the inverter correctly con-
nected to the PROFIBUS?
Have you configured the com-
munication between the inverter
and the higher-level controller?
Do the addresses in the inverter
and the higher-level controller
match?
Is the same telegram set in the
higher-level controller and in the
inverter?
Are the signals that the inverter
and the controller exchange via
PROFIBUS correctly intercon-
nected?
SINAMICS G110M Operating Instructions
Operating Instructions, 04/2015, FW V4.7.3, A5E31298649B AD
Description
See Section: Manuals for your converter
(Page 334).
See Section: Manuals for your converter
(Page 334)
See Section: Settings PROFIBUS DP
address with DIP switches (Page 130).
Adapt the telegram in the inverter. See
Section: Select telegram (Page 131).
Adapt the interconnection of the signals
in the controller to the inverter. For the
PROFIdrive-compliant interconnection in
the inverter, see also Section:
PROFIdrive profile for PROFIBUS and
PROFINET (Page 133).
Configure fieldbus
7.3 Communication via PROFIBUS
Examples
---
See Manuals for your
converter (Page 334)
129