Siemens Sinamics G110M Original Instructions Manual page 44

Installation
4.2 System Installation
3. Fitting the terminal housing to the motor
1. Remove the existing motor terminal housing (the terminal housing
will become the motor terminal housing).
2. Align the terminal housing with the motor terminal housing.
3. Secure the terminal housing to the motor terminal housing.
Notes:
Ensure that the terminal housing is fitted to the motor with the
•
Power Module heatsink over the non-drive end of the motor.
There are three different terminal housings, please ensure you
•
have the correct terminal housing configuration for the motor to
which it is to be fitted.
All the required fixing bolts are supplied in the packaging with the
•
product.
On the FS80/90 terminal housings there are two additional fixing
•
points which are the earthing points between the terminal housing
and the motor. These earthing points must be used and therefore,
the earthing cable does not need to be fitted.
The FS80/90 terminal housings cannot be fitted directly over the
•
terminal block of the motor - the terminal block of the motor must
be removed from the motor, then the terminal housing is fitted to
the motor and then the motor terminal block is fitted back onto the
motor.
For the exact dimensions and fixing points of the terminal hous-
•
ing, please refer to Dimensions of converters and motors
(Page 36).
The tightening torques for fitting the terminal housing to the motor
•
terminal box are contained in the Operating Instructions for the
motor. For further information, please refer to the following docu-
ment: LA/LE motors for mounting on SIMOGEAR gearboxes
(http://support.automation.siemens.com/WW/view/en/60666508).
If the SINAMICS G110M is ordered as a complete system, then
•
all mechanical and electrical installation is completed in the facto-
ry prior to delivery.
44
SINAMICS G110M Operating Instructions
Operating Instructions, 04/2015, FW V4.7.3, A5E31298649B AD