Documenting The Settings For The Basic Functions, Firmware V4.4 - Siemens SIMATIC ET 200pro Series Operating Instructions Manual

Machine manufacturer
The machine OEM confirms the correctness of the settings documented above.
...
A.4.3 Documenting the settings for the basic functions, firmware V4.4 ... V4.7 SP6
Drive = <pDO-NAME_v>
Table A- 6 Firmware version
Name
Control Unit firmware version
SI version, safety functions integrated in the drive (processor 1)
Table A- 7 Monitoring cycle
Name
SI monitoring clock cycle (processor 1)
Table A- 8 Checksums
Name
SI module identifier, Control Unit
SI module identifier, Power Module
SI reference checksum SI parameters (processor 1)
SI reference checksum SI parameters (processor 2)
Table A- 9 Settings of the safety functions
Name
SI enable, functions integrated in the drive
Only for the CU250S-2 Control Unit
SI PROFIsafe address
F-DI switch over discrepancy time
SI STO debounce time
Only for the CU250S-2 Control Unit
SI forced dormant error detection timer
SI forced checking procedure STO via PM terminals time
SIMATIC ET 200pro FC-2 converter
Operating Instructions, 09/2017, FW V4.7 SP9, A5E34257324B AE
Date Name
...
SI enable safe brake control
SI Safe Stop 1 delay time
A.4 Acceptance tests for the safety functions
Company/dept.
...
Number
r18
r9770
Number
r9780
Number
r9670
r9672
p9799
p9899
Number
p9601
p9602
p9610
p9650
p9651
p9652
p9659
p9661
Appendix
Signature
...
Value
<r18_v>
<r9770_v>
Value
<r9780_v>
Value
<r9670_v>
<r9672_v>
<p9799_v>
<p9899_v>
Value
<p9601_v>
<p9602_v>
<p9610_v>
<p9650_v>
<p9651_v>
<p9652_v>
<p9659_v>
<p9661_v>
261