Configuring The Basic Drive Functions - Siemens SINAMICS S120 Manual

4.4

Configuring the basic drive functions

All of the SINAMICS S120 drive lineup settings required to move the axis are
explained in this section.
The configuration of the safety functions is described in a separate section.
Table 4-3: Configuring the basic drive functions
No. Action
Open STARTER from the
existing S7 project.
1.
You can do this by double-
clicking on "Commissioning".
Now go online and start the
automatic drive configuration.
You can go online by pressing
the "Connect to selected target
2.
devices" button.
In the project navigator then
select the entry "Automatic
Configuration".
PROFIsafe SLS Override
Version 1.0, Entry ID: 81682475
4 Configuration and project engineering
Remark
33