Restore The Settings To The Factory Settings (Without Safety Functions) - Siemens SINAMICS G110M Operating Instructions Manual

7. Switch off the converter power supply.
8. Wait until all LEDs on the converter are dark.
9. Switch on the converter power supply again.
You have restored the safety function settings of your converter to the factory settings.
❒
5.5.3

Restore the settings to the factory settings (without safety functions)

Restoring the converter to the factory setting
Procedure with Startdrive
1. Go online.
2. Select "Commissioning".
3. Select "Backing up/reset".
4. Select "All parameters are reset".
5. Press the "Start" button.
6. Wait until the converter has been reset to the factory setting.
You have reset the converter to the factory settings.
❒
Procedure with operator panel
Proceed as follows to reset the converter to factory settings:
1. Select the "Extras" menu
2. Select the "Parameter settings" menu
3. Select the entry "Restore drive to factory settings"
4. Wait until the converter has been reset to the factory setting.
Distributed converter for SIMOGEAR geared motors
Operating Instructions, 10/2020, FW V4.7 SP13, A5E31298649B AL
Commissioning
5.5 Restoring the factory settings
133