P0015 Macros - Siemens Sinamics G110M Original Instructions Manual
Distributed converter for simogear geared motors
Hide thumbs
Also See for Sinamics G110M:
- Operating instructions manual (428 pages) ,
- Function manual (244 pages) ,
- Getting started (100 pages)
Table of Contents
Advertisement
Commissioning
5.2 Basic commissioning
15. A summary of all the settings are displayed.
16. The final screens gives two options:
5.2.6
p0015 Macros
Macros for the CU240M
The macros that are available for the CU240M Control Modules are shown in the figures
below. Macro 7 is the default setting for the CU240M DP and CU240M PN Control Modules,
Macro 21 is the default settings for the CU240M USS Control Module and Macro 30 is the
default settings for the CU240M ASi Control Modules.
Figure 5-9
100
If the settings are correct, select continue.
• Save settings
• Cancel Wizard
If the save option is selected, the settings are saved to
the converter memory. The location of the saved data is
assigned using the "Parameter Saving Mode" function in
"Parameter Settings" in "Menu".
Macro 7 - Switch over between fieldbus and jogging using DI 3 (default DP/PN)
SINAMICS G110M Operating Instructions
Operating Instructions, 04/2015, FW V4.7.3, A5E31298649B AD
Advertisement
Table of Contents
