Installing; Overview Of The Inverter Installation - Siemens SINAMICS G120 Original Instructions Manual

Installing

4.1

Overview of the inverter installation

Installing the inverter
Precondition
Before installation, please check:
● Are the required inverter components available?
● Do you have the necessary tools and small parts/components required to install the
Procedure
To install the inverter, proceed as follows:
1. Install the accessories (reactors, filter or braking
2. Install the Power Module.
3. Install the Control Unit.
You have installed all of the inverter components, and you can now commission the inverter.
Inverter with CU230P-2 Control Units
Operating Instructions, 11/2013, FW V4.6.6, A5E02430659B AG
– Power Module
– Control Unit
– Accessories, e.g. line reactor or braking resistor
inverter?
resistor) for the Power Module:
– Observe the installation instructions that are
supplied with the accessories.
– If you are using more than one base-mounted
component, then you must observe the sequence
when installing.
See also Installing reactors, filters and braking
resistors (Page 42).
See also Installing Power Module (Page 43).
You can find information about your Power Module
in the corresponding Hardware Installation Manual
(http://support.automation.siemens.com/WW/view/en
/30563173/133300).
See also Installing Control Unit (Page 58).
4
41