Siemens SINAMICS G120 Original Instructions Manual page 326

Backing up data and series commissioning
9.1 Backing up and transferring settings using a memory card
Procedure
Proceed as follows to back up your settings on a memory card:
You have backed up the settings of the inverter on the memory card.
326
1. Go online with STARTER, e.g. via a USB cable.
In STARTER, press the "Copy RAM to ROM" button
In your drive, select "Drive Navigator".
2. Select the "Commissioning" button.
3. Select the button to transfer the settings to the memory card.
4. Select the settings as shown in the diagram and start the data backup.
5. Close the screen forms.
1. Remove the USB cable if one is inserted in the inverter.
2. Plug a BOP-2 onto the inverter.
3. Go to the menu level "EXTRAS".
4. In the menu, select "EXTRAS" - "TO CRD".
Inverter with CU230P-2 Control Units
Operating Instructions, 11/2013, FW V4.6.6, A5E02430659B AG
.