Siemens SINAMICS G120 Original Instructions Manual page 424

Appendix
A.5 Handling STARTER
Display options
In this area, you can set how the measurement results are displayed.
● Repeating measurements
This places the measurements that you wish to perform at different times above one
other.
● Arrange the curves in tracks
This means you define whether the trace of all measured values is displayed with respect
to a common zero line – or to separate zero lines.
● Measuring cursor on
This allows you to analyze the measuring intervals in more detail.
Figure A-4 Trace dialog box
424
Inverter with CU230P-2 Control Units
Operating Instructions, 11/2013, FW V4.6.6, A5E02430659B AG