Saving Settings On A Pc - Siemens SINAMICS G120 Original Instructions Manual

9.2

Saving settings on a PC

Precondition
With the supply voltage switched on,
you can transfer the inverter settings
from the inverter to a PG/PC, or the
data from a PG/PC to the inverter.
This requires you to have installed the
STARTER commissioning tool on your
PG/PC.
You will find additional information about STARTER in Section Tools to commission the
converter (Page 39).
Inverter → PC/PG
Procedure
To back up the settings, proceed as follows:
1. Go online with STARTER :
2. Select the button "Download project to PG":
3. To save the data in the PG, select the button:
4. Go offline with STARTER :
You have backed up the settings.
PC/PG → inverter
Procedure
To transfer the settings, proceed as follows:
1. Go online with STARTER :
2. Select the button "Download project to target system":
3. To save the data in the inverter, select the "Copy RAM to ROM" button:
4. Go offline with STARTER :
You have transferred the settings.
Inverter with CU230P-2 Control Units
Operating Instructions, 11/2013, FW V4.6.6, A5E02430659B AG
Backing up data and series commissioning
.
.
.
.
.
.
9.2 Saving settings on a PC
.
.
331