Handling Starter; Change Settings; A.5 Handling Starter - Siemens SINAMICS G120 Original Instructions Manual

A.5

Handling STARTER

A.5.1

Change settings

After the basic commissioning, you can adapt the inverter to your application as described in
the Commissioning guidelines (Page 73).
STARTER offers two options:
● Change the settings using the appropriate screen forms - our recommendation.
● You change the settings using the parameters in the expert list.
Saving settings so that they are not lost when the power fails
The inverter initially only saves changes temporarily. You must do the following so that the
inverter saves your settings securely in the event of a power failure.
Procedure
Proceed as follows to save your settings in the inverter so that they are not lost when the
power fails:
1. Mark the appropriate drive in the project navigator.
2. Click the
You have saved your settings securely in the inverter in case of a power failure.
Inverter with CU230P-2 Control Units
Operating Instructions, 11/2013, FW V4.6.6, A5E02430659B AG
①
Navigation bar: For each inverter function, select the corresponding screen form.
②
tabs: Switch between screen forms.
If you change the settings using screen forms you do not need to know the parameter
numbers.
If you wish to change the settings using the expert list, you need to know the
corresponding parameter number and its significance.
Save (RAM to ROM) button.
Appendix

A.5 Handling STARTER

421