General Data, Pm260 - Siemens SINAMICS G120 Original Instructions Manual

12.2.5.2

General data, PM260

Feature
Line voltage
Input frequency
Power factor λ
Starting current
Pulse frequency
Electromagnetic
compatibility
Braking methods
Degree of protection
Operating temperature
Storage temperature
Relative humidity
Dirt and contamination
Environmental requirements Protected against damaging chemical substances according to environmental class 3C2 to
Shock and vibration
Installation altitude
Standards
Inverter with CU230P-2 Control Units
Operating Instructions, 11/2013, FW V4.6.6, A5E02430659B AG
Version
660 V ... 690 V 3-ph. AC ±10%
The power units can also be operated with a minimum voltage of 500 V –10%. In this case,
the power is linearly reduced.
50 Hz ... 60 Hz, ±3 Hz
0.9
Less than the input current
16 kHz
The devices in compliance with EN 61800-3: 2004 are suitable for Category C1 and C2
environments. For details, see the Hardware Installation Manual, Appendix A2
DC braking, energy recovery (up to 100% of the output power)
IP20 chassis units
LO without derating:
HO without derating:
LO/HO with derating:
-40 °C ... +70 °C (-40 °F ... 158 °F)
< 95% - condensation not permissible
Protected according to pollution degree 2 to EN 61800-5-1: 2007
EN 60721-3-3; 1995
Long-term storage in the transport packaging according to Class 1M2 to EN 60721-3-1:
•
1997
Transport in the transport packaging according to Class 2M3 to EN 60721-3-2: 1997
•
Vibration during operation according to Class 3M2 to EN 60721-3-3: 1995
•
without derating: up to 1000 m above sea level
with derating: up to 4000 m above sea level
CE, C-TICK
0 °C ... +40 °C
0 °C ... +50 °C
to 60 °C
Technical data
12.2 Technical data, Power Modules
For details, see the Hardware
Installation Manual.
For details, see the Hardware
Installation Manual
405