Siemens SINAMICS G120 Original Instructions Manual page 344
Sinamics g120 inverter with cu230p-2 control
units
Hide thumbs
Also See for SINAMICS G120:
- List manual (1256 pages) ,
- Manual (732 pages) ,
- Operating instructions manual (550 pages)
Table of Contents
Advertisement
Corrective maintenance
10.1 Overview of replacing converter components
Device replacement without removable storage medium - only for communication via PROFINET
If you have created a topology in your control, you can use environment detection to replace
a defective inverter with a new device of the same type and with the same software release.
Recommissioning is not required in this case.
You can either load the inverter settings into the inverter using the memory card or – if you
are using a SIMATIC S7 controller with DriveES – using DriveES.
Details of the device replacement without removable storage medium can be found in the
Profinet system description (http://support.automation.siemens.com/WW/view/en/19292127).
Replacing further components
The replacement of further components is described in the hardware installation manual of
the associated Power Module.
344
Inverter with CU230P-2 Control Units
Operating Instructions, 11/2013, FW V4.6.6, A5E02430659B AG
Advertisement
Table of Contents
