Siemens SINAMICS G120 Original Instructions Manual page 196
Sinamics g120 inverter with cu230p-2 control
units
Hide thumbs
Also See for SINAMICS G120:
- List manual (1256 pages) ,
- Manual (732 pages) ,
- Operating instructions manual (550 pages)
Table of Contents
Advertisement
Configuring the fieldbus
7.7 Communication over CANopen
SDO abort codes
Abort code
0503 0000 hex
0504 0000 hex
0504 0001 hex
0504 0002 hex
0504 0003 hex
0504 0004 hex
0504 0005 hex
0601 0000 hex
0601 0001 hex
0601 0002 hex
0602 0000 hex
0604 0041 hex
0604 0042 hex
0604 0043 hex
0604 0047 hex
0606 0000 hex
0607 0010 hex
0607 0012 hex
0607 0013 hex
0609 0011 hex
0609 0030 hex
0609 0031 hex
196
Description
Toggle bit not alternated
Toggle bit has not changed
SDO protocol timed out
Timeout for the SDO protocol
Client/server command specifier not valid or unknown
Client/server command not valid or unknown
Invalid block size (block mode only)
Invalid block size
Invalid sequence number (block mode only)
Invalid sequence number
CRC error (block mode only)
CRC error
Out of memory.
Memory overflow
Unsupported access to an object.
Access to an object that is not supported
Attempt to read a write only object.
Attempt to read a "write-only object"
Attempt to write a read only object.
Attempt to write a "read-only object"
Object does not exist in the object dictionary.
Object does not exist in the object dictionary
Object cannot be mapped to the PDO.
Object cannot be linked with the PDO
The number and length of the objects to be mapped would exceed PDO length.
The number and length of the linked objects exceeds the PDO length
General parameter incompatibility reason.
Basic parameter incompatibility
General internal incompatibility in the device.
Basic incompatibility in the device
Access failed due to an hardware error.
Access failed due to a hardware fault
Data type does not match, length of service parameter does not match.
Data type and length of the service parameter do not match
Data type does not match, length of service parameter too high.
Data type is not correct, service parameter is too long
Data type does not match, length of service parameter too low.
Data type is not correct, service parameter is too short
Subindex does not exist.
Subindex does not exist
Value range of parameter exceeded (only for write access).
Value range of the parameter exceeded (only for write access)
Value of parameter written too high.
Subindex does not exist
Inverter with CU230P-2 Control Units
Operating Instructions, 11/2013, FW V4.6.6, A5E02430659B AG
Advertisement
Table of Contents
