Hr/Hs Receiver (Chest Belt) - Technogym Jog Now Excite+ 700 Service Maintenance Manual

Jog now excite+ series; rev. 5.1
Hide thumbs Also See for Jog Now Excite+ 700:
Table of Contents

Advertisement

6.14.2. HR/HS R
700 models
CORRECT USE OF THE CHEST BELT: Wear the chest belt take care the area of
contact with the body is humid in order to guarantee it proper works.
Replace the connecting
cable between High Kit
and Low Kit.
Page 6.30
(C
B
ECEIVER
HEST
THERE IS NO HR
SIGNAL
(Chest Belt)
Check if using the Hand
Sensors the Heart Rate
detected.
Check if the +5Vdc are at the
input of the Receiver Board.
Are present?
YES
Check if the +5Vdc are at the
output of ARM/CPU Board.
Are present?
ARM/CPU Board
defective.
Replace.
JOG NOW Excite +: Service & maintenance manual - rev. 5.1
)
ELT
YES
NO
1
YES
NO
2
NO
A
OK
NO
Check the SW and the
grounding of Receiver Board.
Problem persist?
YES
Receiver Board
defective.
Replace.
Continued on following page...
3

Advertisement

Table of Contents
loading

This manual is also suitable for:

Jog now excite+ 500

Table of Contents