Checking The Tread Belt Motor Drive-Belt; Checking And Centering The Tread Belt; Checking The Wiring And Connections; Checking The Display - Technogym Jog Now Excite+ 700 Service Maintenance Manual

12.2.8. C
HECKING THE TREAD BELT MOTOR DRIVE
1. Turn off the machine by placing the switch in position 0 (OFF).
2. Unplug the mains lead from the wall outlet.
3. Open the motor guard.
4. Check the state of wear of the tread belt motor drive-belt, turning it by hand using the motor
flywheel. Replace if there are evident signs of wear.
12.2.9. C
HECKING AND CENTERING THE TREAD BELT
1. With the machine stopped, check the tension over the entire surface of the tread belt, turning it
by hand. If any anomalies are found, call in an authorized Technogym service technician.
2. With the machine moving at a speed of approximately 10 km/h, check the centring of the tread
belt. Replace if there are evident signs of wear.
12.2.10. C
HECKING THE WIRING AND CONNECTIONS
1. Open all the machine guards.
2. Check the condition of all the cables:
• External conditions;
• Possible rusting of the connectors;
• Electrical continuity of the individual wires;
• Isolation of the individual wires toward ground.
3. Repair and/or replace any non-conforming wires. Check the condition of the fuses using a tester.
12.2.11. C
HECKING THE DISPLAY
1. Check the operation of all the keys on the keyboard.
2. Check the operation of all the LEDs and the buzzer.
3. Check VISIO Touch Screen calibration.
Pagina 12.4
JOG NOW Excite +: Service & maintenance manual - rev. 5.1
-
BELT