Technogym Jog Now Excite+ 700 Service Maintenance Manual page 85

JOG NOW Excite +: Service & maintenance manual - rev. 5.1
Error
Error Description
code
Motor overload caused by a DC current
exceeding, for the maximum allowed
11 11/OLm
time (I2t), the maximum permissible
threshold for the motor in question.
12 12/OLr Braking resistor overload.
EMERGENCY. Is generated when low
kit drive receives a software emergency
19 19/EM
signal that is not accompanied by a
hardware emergency signal
LOW KIT DRIVER COVER PLATE
FAN. This error is generated if there is
20/SFA
20 a malfunction on the fan mounted on
n
the driver's cover plate, for at least 5
sec.
LOW KIT DRIVER INTERNAL FAN.
21/PFA This error is generated if there is a
21
n malfunction on the internal low kit
driver fan, for at least 5 sec
INVERTER POWER SUPPLY: This
error is generated if a voltage <156
22 22/IMV VAC for at least 1 sec. when the AC
motor is working or for at least 10 sec.
when AC motor is not working.
SHORT CIRCUIT. Is generated in the
23 23/SHC event of a short circuit between a motor
phase and earth.
OVERHEATING of the dissipater
sensor: This error is generated if a
24 24/OHS
malfunction of the dissipater sensor last
more than 1 sec.
Note (*):
In case of errors related to high current consumption (such as E01), we recommend performing a
test that consists of walking on the treadmill at a pre-established speed and checking the current
consumption, according to the table below.
USER WEIGHT
60Kg
70Kg
80Kg
On models not equipped with an encoder, in which the speed readout is always "0", use the
frequency value given in the table as a reference.
FREQUENCY/SPEED
1500Hz / 5Km/h
1500Hz / 5Km/h
1500Hz / 5Km/h
Possible solution
-
• Check the resistor=150 Ω;
low kit
Driver.
•
-
low kit driver
• cover plate fan.
low kit driver
internal fan.
•
-
• Check the belt motor.
low kit d
• river;
(*).
•
CURRENT DRAW
5A
5.3A
5.6A
Page 6.19