Mechanical Safety Test; Checking The Assembly Of The Tread-Belt Components; Checking The Assembly Of The Guards; Start-Up Check - Technogym Jog Now Excite+ 700 Service Maintenance Manual

JOG NOW Excite +: Service & maintenance manual - rev. 5.1

11.2. MECHANICAL SAFETY TEST

11.2.1. C
HECKING THE ASSEMBLY OF THE TREAD
Check that the following have been correctly assembled: tread belt, running deck and rollers. In
particular, make sure that:
• The tread belt has been properly assembled, and its tension correctly adjusted it.
• The running deck is in good condition and has been correctly assembled.
• The front and rear rollers have been correctly assembled and do not produce any unusual
noise during operation.
• The footboard has been correctly assembled.
11.2.2. C
HECKING THE ASSEMBLY OF THE GUARDS
Check the correct assembly of the machine guards, making sure they are all in place and correctly
secured so that no part of the machine is left exposed that may cause injury to the user.

11.3. START-UP CHECK

Following installation and after every technical intervention on the machine, plug it into a power
outlet, set the power switch to ON.
During power-up the machine resets the incline. After completing the power-on reset, the machine
goes into standby, awaiting a keyboard command.
To check the correct operation of the machine:
• get on the machine;
• press the "Quick Start" key to begin exercising and check that the tread belt motor starts;
• press the "+" and "-" keys on the keyboard and check that the tread belt speed varies
accordingly;
• press the " ↑ " and "
• press the emergency button and check that the tread belt stops;
• put on the heart rate meter and check that the machine correctly reads the heart rate value;
• grasp the sensors and check that the machine correctly reads the heart rate value;
Pagina 11.3
↓ " keys and check that the incline varies accordingly;
-
BELT COMPONENTS