Adjustments; Tensioning The Tread Belt; Tensioning A New Tread Belt - Technogym Jog Now Excite+ 700 Service Maintenance Manual

JOG NOW Excite +: Service & maintenance manual - rev. 5.1

8. ADJUSTMENTS

8.1. TENSIONING THE TREAD BELT

8.1.1. T
ENSIONING A NEW TREAD BELT
Figure 8-1
Figure 8-2
Do not measure the tread belt on the
junction area, in order to keep the
correct value.
1. After replacing the tread belt, place a tape
measure along the centre of the tread belt and
use a pen to make two reference marks
spaced exactly 1m apart.
2. Lock down by turns the 2 screws (a) until the
distance between
increases by 6mm.
Take care that the roller is always
approximately parallel with the one on
the front, to counteract the tension
exerted by the belt on the roller
bearings.
After completing this procedure, any
further adjustments
performed using only the left-hand
alignment screw.
CAUTION:
procedure, check the centring of the
tread belt as instructed in paragraph:
8.3 "Centring the tread belt".
the reference
should
After completing
Page 8.1
marks
be
this