Enable Custom Messages; Enable Up/Down Motor; Resetting Parameters To Default Values; Format P&P - Technogym Jog Now Excite+ 700 Service Maintenance Manual

9.1.14. E
NABLE CUSTOM MESSAGES
It is possible to configure whether a custom message is displayed when the machine is in the
standby state. To change the selection, when the LED matrix shows the current setting:
Press the +/- GOAL number keys to select the desired option out of those listed in the table below:
9.1.15. E
NABLE UP
This parameter enables or disables use of the machine incline. To change the selection, when the
LED matrix shows the current setting:
Press the +/- GOAL number keys to select the desired option out of those listed in the table below:
9.1.16. R
ESETTING PARAMETERS TO DEFAULT VALUES
It is possible to reset the user menu parameters to their default values. To select the function, when
the LED matrix shows:
Press ENTER to confirm the operation, use the + or – speed keys to move to the next or
proceeding.
9.1.17. F P&P
ORMAT
This function formats a TGS key for Plug & Play mode operation. To select the function, when the
LED matrix shows:
Press ENTER to confirm the operation, use the + or – speed keys to move to the next or preceding
parameter.
At the end of the format procedure, hold down the CLEAR key for a few seconds to exit.
The CLEAR key can be pressed at any time to interrupt the procedure and revert to Stand-By mode.
Pagina 9.6
CUSTOM MESS.: xxx
CUSTOM MESS.
YES
NO
/
DOWN MOTOR
UP - DOWN: xxx
U - D
P OWN
ENABLED
DISABLED
DEFAULT CONFIG.
FORMAT P&P
JOG NOW Excite +: Service & maintenance manual - rev. 5.1
<default>
<default>