7.7. DISASSEMBLING THE HAND SENSOR
Only for 700 LED and VISIO models.
Figure 7.7-1
Figure 7.7-2
Page 7.22
JOG NOW Excite +: Service & maintenance manual - rev. 5.1
Turn off the machine and unplug the mains lead
from the wall outlet.
For each sensor:
1. Back off the 2 screws (a) using a small
Phillips screwdriver.
2. Raise the upper and inferior sensor; unplug
the 2 fast-on (b) and (c).
3. Remove the 2 sensors.
During the reassembly: be careful to
don't press the cables, using the two
guides highlight in the figure on the side.
To reassemble the sensors, carry out the above
steps in reverse order.