Do you have a question about the RUN 1000 and is the answer not in the manual?
Questions and answers
Elchin Azimov
April 4, 2025
Could you please qive me If system blocked,How does restart and what is a problem
1 comments:
Mr. Anderson
April 4, 2025
To restart a blocked Technogym RUN 1000 treadmill, press any key. A few seconds after the key is pressed, the equipment enters standby mode.
The problem could be due to the user not being detected. If the treadmill stops despite the user being present, adjust the “user present” function activation speed as described in the manual.
Connection to another device..............22 Routine maintenance ..................24 Aligning the treadmill ...................28 Troubleshooting .....................29 Technical assistance ..................31 Storage ......................32 Disposal ......................32 Switching on and off ..................33 Monitoring the heart rate ................34 Using the equipment ..................37 Run 1000 - Run 600 Excite...
Any other use is to be considered improper and therefore dangerous. Do not use attachments not recommended by Technogym. Never operate the equipment if it has a damaged cord or plug, if it is not working properly, if it has been dropped or damaged, or dropped into water. In this case, contact the Technogym Technical Support service.
Page 4
SAVE THESE INSTRUCTIONS Warnings Do not connect a device with load exceeding 7A. Risk Of Electric Shock. Do Not Disconnect Under Load. Do not connect to a circuit operating at more than 150V to Ground. Run 1000 - Run 600 Excite...
Keep all electrical components, such as the power cable and I/0 switch, away from liquids to prevent shock. Maintain the equipment in good working condition. If there are signs of wear, contact the Technogym Technical Support service. Do not attempt to service the equipment yourself other than the maintenance instructions found in the user manual.
Page 6
Do not set anything on the casing or control panel. Technogym is not responsible for any damages due to any failures or damage caused by unauthorized service, misuse, accident, negligence, improper assembly or installation, debris resulting from any construction activities in the product’s environment, rust or corrosion as a result of the product’s location, alterations or modifications without Technogym’s written authorization or for failure on your part to use, operate and maintain the products...
D - Electrical specifications E - Tells you to consult the User manual F - Serial number and date of manufacture G - Product model Technogym S.p.A. via Calcinaro 2861, Cesena (FC) Made in Italy RUN 1000 Model no. DEK8EU...
Page 8
Products marked with the code DEK8M.. / DEK6M.. may be used by or near children, invalids, disabled persons or people with evident physical problems only under close supervision of a doctor or a qualified professional. Run 1000 - Run 600 Excite...
Object holder (E): for standing the water bottle or other useful items on during the workout. Hand sensor (F): the metal plate sensors permit constant heart rate monitoring. Fast Track control (G): for changing the treadmill speed and gradient during the exercise. Run 1000 - Run 600 Excite...
Page 10
Central handgrip (M): can be held when walking with small strides. Footrests (N): you can take a short rest by moving your feet from the treadmill to the footrests, in the event of fatigue or danger. Run 1000 Run 600 Run 1000 - Run 600 Excite...
2 kg (4 lb) 2 kg (4 lb) 2 kg (4 lb) holder Electric isolation class Class I Class I Class I The maximum power values refer to a user weighing a maximum of 100 kg. Run 1000 - Run 600 Excite...
Page 12
Maximum capacity of water bottle-holder 2 kg (4 lb) 2 kg (4 lb) Electric isolation class Class I Class I The maximum power values refer to a user weighing a maximum of 100 kg. Run 1000 - Run 600 Excite...
Page 13
Technical data 2190 mm 960 mm (86") (38") 1551 mm (61") Run 1000 2101 mm 859 mm (83") (34") 1481 mm (58") Run 600 Run 1000 - Run 600 Excite...
If no user is detected for 30 seconds when at a speed of 3 km/h or more, the belt stops and the exercise is paused. At minimum speed, the user is detected only if they weigh at least 50 kg. Run 600 Run 1000 - Run 600 Excite...
Page 15
The label (F) which can be attached to the power supply cable states the electrical specifications for the cable. Warning Please read the adhesive labels on the equipment, which provide information about possible risks and hazards. Run 1000 Run 600 Run 1000 - Run 600 Excite...
Page 16
In motion light (H) The luminous red signal located on the left handle shows that the treadmill is moving. Do not climb onto the product while the treadmill is moving. Run 1000 Run 600 Run 1000 - Run 600 Excite...
Do not operate where aerosol (spray) products are being used or where oxygen is being administered. Do not install the equipment in areas with high humidity levels, for example close to swimming pools, whirlpools or saunas. Run 1000 - Run 600 Excite...
Run 600 transport methods. Warnings When lifting, it is recommended to grip the frame and not the plastic parts. Move the equipment with great care to avoid it tipping over. Run 1000 - Run 600 Excite...
The equipment is levelled by adjusting the rear foot on the side shown in the illustration: loosen the lock nut (B); screw the foot (A) in or out until the frame is in a stable position; tighten up the lock nut (B) after adjusting. Run 1000 Run 600 Run 1000 - Run 600 Excite...
When plugging in, the switch on the equipment must be in the Run 1000 OFF (0) position (i.e. the equipment must be switched off). Run 600 Run 1000 - Run 600 Excite...
Page 21
B - Shows which sides the ON and OFF (I and 0) positions are. The ON (I) / OFF (0) positions may vary according to the equipment version. The correct positions are given on the label on the equipment. C - Shows the type of switch (two fixed positions). Run 1000 Run 600 Run 1000 - Run 600 Excite...
Page 22
Do not modify the plug provided with the product; if it will not fit in the outlet, have a proper outlet installed by a qualified electrician. Run 1000 - Run 600 Excite...
IEC 60601-1 standard about systems. Consult the technical support department or your local representative if you have any doubts. Run 1000 Run 600 Run 1000 - Run 600 Excite...
Page 24
The wall socket of the aerial cable must be positioned so that the plug can be easily inserted and removed. A network socket can be found next to the aerial socket for the Ethernet connection. Run 1000 Run 600 Run 1000 - Run 600 Excite...
The safety of the equipment is assured only on the condition that it is carefully inspected every two weeks for any signs of damage and/or wear. If used for medical purposes, disinfect the hand sensors each time the equipment is used. For maintenance actions not described in this manual, call in the Technogym Technical Service. Run 1000 - Run 600 Excite...
Page 26
Warnings The routine maintenance, adjustment and lubrication jobs must be performed by the Technogym Technical Support Service. Before starting any job, turn the equipment off by switching the switch to the OFF (0) position and unplug the power cable from the wall socket.
Page 27
Clean the dust panel and the surrounding area every month: remove the guard, extract the panel from its guides and clean it with a vacuum cleaner. For safety reasons, always replace the dust panel. Run 1000 Run 600 Run 1000 - Run 600 Excite...
Page 28
With the rotating belt in motion at 5 km/h press the emergency push button to ensure that the belt stops. If the emergency push button does not work properly place the product out of service and contact Technogym Technical Support Service.
Turn the adjustment screw (A), on the side shown in the illustration, using the supplied tool (B), until the writing is equidistant from both sides. Warning The treadmill realigns slowly: turn the adjustment screw ¼ or ½ a turn and then check the result before turning it again. Run 1000 Run 600 Run 1000 - Run 600 Excite...
Treadmill not centrally aligned. "Aligning the treadmill". Data incorrect or Equipment next to source of radio interference (e.g. Move the equipment to another place or move the household unreliable with electrical household appliances). appliances. equipment running Run 1000 - Run 600 Excite...
Page 31
Worn heart rate monitor chest band. Change the chest band. Chest band transmitter not making proper skin contact. Dampen the inside of the chest band with water. Damaged transmitter. Change the chest band. Run 1000 - Run 600 Excite...
Via Calcinaro 2861, 47521 Cesena Italy tel: +39 0547 56047 supply of original spare parts. http://www.technogym.com/Support When you contact the Technogym Technical Support Service you must give the following information: model, date of purchase, serial number, precise description of the problem.
Following measures implemented by the member states of the European Union, private citizens resident in the EC can take their used electrical and electronic equipment to authorised collection centres for disposal. If the product is used commercially, contact your reseller or Technogym Customer Service in your country to arrange collection and disposal of the electrical or electronic waste.
The switch is for turning the equipment on and off but does not isolate it completely from the mains voltage, even in the “OFF” (0) position. For complete isolation you must unplug the power supply plug. Run 1000 Run 600 Run 1000 - Run 600 Excite...
80 cm. Heart rate readings will not be accurate near electromagnetic radiation sources (TVs, cellphones, etc.). Should you have any doubts about the accuracy of the readings, contact the Technical Support Service. Run 1000 - Run 600 Excite...
Page 36
Combined use of fats and sugars Significant improvement of aerobic efficiency. Prevalent use of fats and increased use of sugars Moderate improvement of aerobic efficiency. Prevalent use of fats, and modest use of sugars Limited improvement of aerobic efficiency. Run 1000 - Run 600 Excite...
Page 37
The heart rate shown on the display is purely indicative and cannot be considered to be absolutely certain. You are advised not to use a chest band with heart rate monitor if you have a cardiac support device such as a pacemaker or similar. Run 1000 - Run 600 Excite...
To get off the device in an emergency, grasp the side handgrips, support your weight on them and move your feet onto the footrests. Then get off the equipment. Run 1000 - Run 600 Excite...
Page 39
Run is to be used solely for its intended purpose, i.e. to simulate walking and running. Any other use of the equipment is to be considered improper and therefore dangerous. Preventing use of the product To prevent unsupervised use of the product, remove the power supply cable and keep it in a safe place. Run 1000 - Run 600 Excite...
Need help?
Do you have a question about the RUN 1000 and is the answer not in the manual?
Questions and answers
Could you please qive me If system blocked,How does restart and what is a problem
To restart a blocked Technogym RUN 1000 treadmill, press any key. A few seconds after the key is pressed, the equipment enters standby mode.
The problem could be due to the user not being detected. If the treadmill stops despite the user being present, adjust the “user present” function activation speed as described in the manual.
This answer is automatically generated