Tread Belt Relaxed (Effects: Noisy Tread Belt) - Technogym DGK02U0 Technical Service Manual

REAR PART
ADJUSTABLE
BEARING

6.2.2 TREAD BELT RELAXED (EFFECTS: NOISY TREAD BELT)

• The belt must lightly touch the front bearing. More specifically, there must be a maximum
gap of 1 mm to 2 mm between the belt and the front bearing. The belt may lightly touch the
bearing, but must not be overtensioned: as soon as the belt is in contact with the bearing,
do not rotate the front pin bolt any further. Tuen both the right and left bolts on the front
roller to maintain the parallelism.
Maintain the parallelism of the rollers. This is important as regards the position of the tread
belt on the equipment. Turn one half turn at a time, both on the right and on the left side of
the roller.
REAR PART
ADJUSTABLE
BEARING
• Check that the adjustable bearings are in contact:
_loosen the central bearing;
_check and if necessary adjust the rear bearing to bring it into contact with the belt. Tighten.
_let the central being fall onto the belt and tighten.
- 66 -
TECHNOGYM RUN Technical Service Guide
ADJUSTABLE
BEARING
Fig. 26
ADJUSTABLE
BEARING
Fig. 27
TSG-00284-EN- Uncontrolled copy if printed
Rev. 1.0
FRONT PART
FIXED
BEARING
FRONT PART
FIXED
BEARING