JOG NOW Excite +: Service & maintenance manual - rev. 5.1
7.8. DISASSEMBLING THE INMOTION – (READY TO RUN)
BOARD
Figure 7.8-1
Figure 7.8-2
Figure 7.8-3
Turn off the machine and unplug the mains lead
from the wall outlet.
1. Back off the screw (a) using a small Phillips
screwdriver.
2. Remove InMotion board closing covering (b)
from the handlebar.
3. Unplug the connector (c) from the Board.
4. Remove the Board (d).
To reassemble the InMotion board, carry out the
above steps in reverse order.
Take care to reassemble it in the correct
way:
The light convector (e): it's not possible
to mount it in the opposite way in order
to correctly fix it on the board.
The InMotion board: the upper corner
of the board (circled in the figure) has
been cut to correctly housing in the
plastic cover
Page 7.23