Config Registers - Technogym Jog Now Excite+ 700 Service Maintenance Manual

9.2.6.2. Config. Registers
This function displays the parameter values of type b, C, D, F, P, H and S. To access this menu,
when the LED display shows:
Press ENTER, the following message appears:
Where X is the address identifying a Driver parameter, as detailed in the tables at the end of the
paragraph.
Press ENTER to change the address and select a different parameter, or press + to read the value of
the currently selected parameter, the following message will appear:
Press ENTER to load the parameter value, the following message will appear:
Press ENTER to begin editing the parameter value. When finished, press + and the following
message will appear:
Press ENTER to confirm writing the changes to the low kit; at the end of this operation the
following message reappears:
Although the changes made to the parameters come into effect immediately, they are not
automatically stored in permanent memory; this requires a specific write operation
effected using the command C-0: at address 800 write the value "1", following the
detailed instructions provided in paragraph 9.2.6.2 "Config. ".
To return to the upper menu level press CLEAR for a few seconds.
The inverter parameters are listed at paragraph: 9.4.3. "Inverter".
Pagina 9.18
JOG NOW Excite +: Service & maintenance manual - rev. 5.1

CONFIG REGISTERS

ADDRESS: X
READ FROM LOW KIT ?
VALUE: Y
WRITE TO LOW KIT ?
ADDRESS: X