JOG NOW Excite +: Service & maintenance manual - rev. 5.1
7.14. DISASSEMBLING THE LOWER GUARD
Figure 7.14-1
2. To make the procedure easier, turn the machine over on one side, as shown in the figure.
3. Loosen the 7 screws (a) using a 4mm hexagonal wrench.
During the reassembly: leave the screws allow for the reassembly of the motor guard.
Carry out the procedure described in paragraph:
7.13. "Disassembling the motor guard".
1. Disconnect the limit switch cable from the
driver box.
Figure 7.14-2
Continued on following page...
Page 7.29